Torque Limiter 65-1-080

Price on Request
In Stock

Torque Limiters

• Prevent machine damage
• Eliminates costly down time
• No expensive electronics
• Simple installation
• No manual resetting required

Torque Limiters

The Challenge range of torque limiters are a mechanical protective device that limit the transmitted torque in a drive system when the torque demand exceeds a pre-set value. Torque limiters are available for torque ranges from 3Nm up to 1090Nm. All torque limiters are supplied pilot bored or machined to suit our customers requirements (upon request) and can accommodate shaft diameters from 9mm up to 64mm.

Machine Protection - Torque Limiters
The Challenge range of slip clutch/friction plate torque limiters are an automatic device that protect equipment from overload damage due to crash stops and jams. Unlike shear pins which must be reset, friction plate limiters continue to operate once the load has been reduced below a safe level. The safe level at which the clutch will slip can be set for each limiter using a nut or screws.

Prevent Damage and Down Time
Torque limiters can be used as a cheap and effective method to prevent equipment damage caused by full power from the drive if a snag or jam occurs. The automatic slip clutch limiter disconnects the main drive from the system, which prevents further damage if the drive transmits its full power. These limiters require no expensive electronics, are self resetting and can help eliminate costly down time.

Simple to Install and Use
Sprockets, gears, pulleys couplings etc can all be easily protected with torque limiters when used as the central member which is clamped between two discs. Challenge torque limiters utilize spring loaded friction discs for their operation and slip torque is present by adjustment of the spring force using the adjustment nut or bolts. Because the Challenge torque limiter ratings are realistic and consistent with optimum spring loads, they permit longer slip time, maintain re-engagement at present torque and provide long lasting machine protection.

Unit of Sale; Per Unit

More Information
Torque Limiter65
Limiter - Size65-1
Limiter - Torque Range - kg.m0.7 ~ 2.8
Limiter - Plain Bore10
Limiter - Max. Bore22
Limiter - Bush Length8
Limiter - O.D. Of Bush41 - 0.025 / - 0.050
Limiter - Bore For Centre Member41 + 0 / + 0.039
Limiter - Outside Diameter65
Limiter - Hub Diameter35
Limiter - Total Distance Thro.48
Limiter - Hub Length16
Limiter - Pressure Plate Thickness4
Limiter - Friction Plate Thickness3.2
Limiter - Max Gap Between Friction Plates9
Limiter - Set Screw Centre4
Limiter - Adjustment Nut Size50
Limiter - Adjustment NutM35 P1.5
Limiter - Adjustment Bolt-
Limiter - Set ScrewM5
Limiter - Weight - kg0.721
Stock Code411-006
Full Catalogue (99.30 MB)
Ask a question about: Torque Limiter 65-1-080